Connectivity
Battery Alert
Configure Battery Alert in HPzenAi Smart. Warns before battery-powered devices go offline.
What it does
Replace batteries before devices go dark.
Warns before battery-powered devices go offline. Use this automation when the selected field devices should work together without repeated manual setup.
Automation Logic
Trigger
Battery level falls below the selected warning point.
Battery drops below 20%
Example: choose "Battery drops below" and keep the default 20%, select another preset, or enter another value.
Condition
The device reports a recent battery level.
No condition
Example: leave No condition selected when the trigger alone should run the workflow.
Action
Send a battery replacement or recharge alert.
Notify me (warning)
Example: choose "Notify me (warning)" for the default then behavior.
Allowed Time
Use All day for battery monitoring.
All day
Example: keep All day for protection workflows, or choose Day or Night when operation should stay inside site hours.
Automation Details
Recommended use
Battery-powered sensors, tags, and field devices.
Gateways, Water Meters, Level Sensors, Valves
Send a battery replacement or recharge alert.
Replace batteries early for devices used in safety or protection workflows.
Confirm battery level is visible on the device tile before enabling the alert.
Before You Start
Device Readiness
Link every device used by this workflow and confirm each one is online.
Device Selection
Choose the exact tank, pump, valve, relay, or meter that should be controlled.
Safe Test
Test with safe thresholds or manual observation before leaving the workflow enabled.
Guided Setup
Set Up Battery Alert
Open the HPzenAi app.
Commissioning Checks
- Confirm the notification or failsafe action happens when device communication changes.
- Confirm battery level is visible on the device tile before enabling the alert.
- Confirm the saved card shows the correct workflow, devices, schedule, and enabled state.
- Review the event history after testing so the action is recorded as expected.
- Keep safety-critical workflows active all day unless the site needs a specific time window.
Troubleshooting
- If the Save button is disabled, complete every required trigger, condition, action, and timing field.
- If the workflow does not run, confirm the devices are online and the active time allows it to run now.
- If the action does not complete, check whether the target device is already in that state or cannot accept commands.
- If notification behavior is missing, confirm phone notification permission and recent device data.