Motor & Energy
Maintenance Runtime
Configure Maintenance Runtime in HPzenAi Smart. Schedules service based on accumulated motor runtime.
What it does
Schedule service based on accumulated motor runtime.
Schedules service based on accumulated motor runtime. Use this automation when the selected field devices should work together without repeated manual setup.
Automation Logic
Trigger
Runtime reaches the selected maintenance interval.
Total runtime passes 500 h
Example: choose "Total runtime passes" and keep the default 500 h, select another preset, or enter another value.
Condition
Runtime tracking is enabled for the selected motor.
No condition
Example: leave No condition selected when the trigger alone should run the workflow.
Action
Send a maintenance reminder.
Notify me (warning)
Example: choose "Notify me (warning)" for the default then behavior.
Allowed Time
Use All day for continuous runtime tracking.
All day
Example: keep All day for protection workflows, or choose Day or Night when operation should stay inside site hours.
Automation Details
Recommended use
Pumps and motors with service intervals based on operating hours.
Motor Controllers, Energy Meters, Level Sensors
Send a maintenance reminder.
Reset or update the maintenance counter only after service is complete.
Use a temporary low interval to confirm the reminder appears.
Before You Start
Device Readiness
Link every device used by this workflow and confirm each one is online.
Device Selection
Choose the exact tank, pump, valve, relay, or meter that should be controlled.
Safe Test
Test with safe thresholds or manual observation before leaving the workflow enabled.
Guided Setup
Set Up Maintenance Runtime
Open the HPzenAi app.
Commissioning Checks
- Confirm the motor action or alert follows the selected protection condition.
- Use a temporary low interval to confirm the reminder appears.
- Confirm the saved card shows the correct workflow, devices, schedule, and enabled state.
- Review the event history after testing so the action is recorded as expected.
- Keep safety-critical workflows active all day unless the site needs a specific time window.
Troubleshooting
- If the Save button is disabled, complete every required trigger, condition, action, and timing field.
- If the workflow does not run, confirm the devices are online and the active time allows it to run now.
- If the action does not complete, check whether the target device is already in that state or cannot accept commands.
- If notification behavior is missing, confirm phone notification permission and recent device data.