Scenes
Holiday Mode
Configure Holiday Mode in HPzenAi Smart. Locks down water control while the site is unattended.
What it does
Lock the water down while you are away.
Locks down water control while the site is unattended. Use this scene when the selected field devices should work together without repeated manual setup.
Automation Logic
Trigger
A user taps Run before leaving the site.
When I run it from the app
Example: tap Run on the saved card when you want this action to happen.
Condition
The selected valves, relays, or pumps are online.
No condition
Example: leave No condition selected when the trigger alone should run the workflow.
Action
Close or disable selected water paths and pause chosen automations.
Close valves, stop pumps, relays off, arm critical alerts
Example: choose "Close valves, stop pumps, relays off, arm critical alerts" for the default then behavior.
Allowed Time
Manual scene. Use when the site should stay protected until users return.
All day
Example: keep All day for protection workflows, or choose Day or Night when operation should stay inside site hours.
Automation Details
Recommended use
Homes, offices, and remote sites left unattended.
Motor Controllers, Valves, Relay Controllers
Close or disable selected water paths and pause chosen automations.
Confirm critical water needs are not disabled before enabling holiday behavior.
Run once during commissioning and confirm every selected device enters the intended state.
Before You Start
Device Readiness
Link every device used by this workflow and confirm each one is online.
Device Selection
Choose the exact tank, pump, valve, relay, or meter that should be controlled.
Safe Test
Test with safe thresholds or manual observation before leaving the workflow enabled.
Guided Setup
Set Up Holiday Mode
Open the HPzenAi app.
Commissioning Checks
- Confirm the scene only runs when a user taps Run.
- Run once during commissioning and confirm every selected device enters the intended state.
- Confirm the saved card shows the correct workflow, devices, schedule, and enabled state.
- Review the event history after testing so the action is recorded as expected.
- Keep safety-critical workflows active all day unless the site needs a specific time window.
Troubleshooting
- If the Save button is disabled, complete every required trigger, condition, action, and timing field.
- If the workflow does not run, confirm the devices are online and the active time allows it to run now.
- If the action does not complete, check whether the target device is already in that state or cannot accept commands.
- If notification behavior is missing, confirm phone notification permission and recent device data.