Tank & Pump

Tank Full Stop

Configure Tank Full Stop in HPzenAi Smart. Stops filling before the tank reaches overflow.

What it does

Stop the pump when the tank is full.

Stops filling before the tank reaches overflow. Use this automation when the selected field devices should work together without repeated manual setup.

CategoryTank & Pump

Works with

Level SensorsMotor ControllersGateways

Automation Logic

When

Trigger

Tank level reaches the selected full or high-level stop point.

Default

Tank level reaches 90%

Choices

Tank level reaches80%90%95%100%Enter value

Example: choose "Tank level reaches" and keep the default 90%, select another preset, or enter another value.

If

Condition

The pump or inlet valve controlled by HPzenAi is currently running or open.

Default

No condition

Choices

No condition

Example: leave No condition selected when the trigger alone should run the workflow.

Then

Action

Stop the pump or close the filling path for the selected tank.

Default

Turn off the pump

Choices

Turn off the pumpTurn off the pump and notify meOnly notify me

Example: choose "Turn off the pump" for the default then behavior.

Active

Allowed Time

Use All day for overflow protection.

Default

All day

Choices

All dayDay (6 AM - 6 PM)Night (6 PM - 6 AM)

Example: keep All day for protection workflows, or choose Day or Night when operation should stay inside site hours.

Automation Details

Recommended use

Any tank where the fill source must stop automatically at a safe high level.

Device Inputs

Level Sensors, Motor Controllers, Gateways

Output Behavior

Stop the pump or close the filling path for the selected tank.

Safety Note

Set the full level with enough margin for sensor delay and pipe drain-back.

Test Method

Use a safe simulated high level and confirm the pump or valve stops immediately.

Visual reference coming soon

Future screenshot area for the Tank Full Stop setup screen and saved Smart card.

Tank Full Stop Walkthrough

Walkthrough video coming soon

Before You Start

Device Readiness

Link every device used by this workflow and confirm each one is online.

Device Selection

Choose the exact tank, pump, valve, relay, or meter that should be controlled.

Safe Test

Test with safe thresholds or manual observation before leaving the workflow enabled.

Guided Setup

Set Up Tank Full Stop

Step 1 / 12

9:41

1

Open the HPzenAi app.

Step 1 / 12

Commissioning Checks

• Confirm the pump starts and stops at the expected tank levels.
• Use a safe simulated high level and confirm the pump or valve stops immediately.
• Confirm the saved card shows the correct workflow, devices, schedule, and enabled state.
• Review the event history after testing so the action is recorded as expected.
• Keep safety-critical workflows active all day unless the site needs a specific time window.

Troubleshooting

• If the Save button is disabled, complete every required trigger, condition, action, and timing field.
• If the workflow does not run, confirm the devices are online and the active time allows it to run now.
• If the action does not complete, check whether the target device is already in that state or cannot accept commands.
• If notification behavior is missing, confirm phone notification permission and recent device data.

Create an AutomationWorkflow CatalogSchedules & Active TimeTroubleshooting